Panasonic VDRD200 Dvd Camcorder-english/spanish - Page 135
Troubleshooting
View all Panasonic VDRD200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Troubleshooting Troubleshooting Unit operations Problem This unit cannot be turned on. This unit is turned off automatically. This unit does not stay on long enough. Battery runs down quickly. This unit cannot be operated though powered up. This unit does not operate normally. The screen has changed suddenly. The DISC EJECT lever does not work. Check points ≥ Is the battery fully charged? # Charge the battery using the AC adaptor. (l 24) ≥ If you do not use the unit for approximately 5 minutes, the power is automatically turned off to conserve the battery charge. To resume recording, turn the power back on. The power will not turn off automatically when the power save function (l 127) is set to [OFF]. ≥ Is the battery low? # If the remaining battery power indication is flashing or the message "LOW BATTERY." is displayed, the battery has run down. Charge the battery. (l 24) ≥ Is the battery fully charged? # Charge it with the AC adaptor. (l 24) ≥ Are you using the battery in an extremely cold place? # The battery is affected by ambient temperature. In cold places, the operating time of the battery becomes shorter. ≥ Has the battery worn out? # The battery has a limited life. If the operating time is still too short even after the battery is fully charged, the battery has worn out and can no longer be used. ≥ Press the RESET button. (l 138) If normal conditions are not restored yet, remove the battery or AC adaptor, wait about 1 minute and then reconnect the battery or AC adaptor. Then about 1 minute later, turn on the power again. (Conducting the above operation when the access lamp is on may destroy the data on the disc or card.) ≥ Has the demonstration started? # If you set [DEMO MODE] to [ON] without inserting a disc or a card in disc recording mode or card recording mode, the unit is automatically set to the demonstration mode for introducing its functions. Normally this should be set to [OFF]. Press the MENU button, then select [SETUP] # [DEMO MODE] # [OFF] and press the joystick. ≥ The disc cover will not open unless the unit is powered. # Connect a charged battery or AC adaptor. ≥ The DISC EJECT lever does not work when the unit is connected to the computer. (l 139) Others 135 LSQT0969