Panasonic VDRD310 Dvd Camcorder - English/spanish - Page 128

The DISC EJECT lever, Has the DVD-RW Video format or DVD-R been finalized?

Get Panasonic VDRD310 - DVD CAMCORDER PDF manuals and user guides View all Panasonic VDRD310 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 128 highlights

Others Problem The remote control does not function. The DISC EJECT lever does not work. The disc cannot be read. A function indication such as the remaining time indication or the elapsed time indication is not shown. Recording does not start although power is supplied to this unit and the disc or card is correctly inserted. Recording starts but stops immediately. The playback picture breaks up for a moment. The unit arbitrarily stops recording. Check points ≥ Has the button-type battery of the remote control run out? # Replace it with a new button-type battery. (l 20) ≥ The disc cover will not open unless the unit is powered. # Connect a charged battery or AC adaptor. ≥ The DISC EJECT lever does not work when the unit is connected to the computer. (l 131, 132) ≥ Are there fingerprints or dirt on the surface of the disc? # If there are fingerprints or dirt on the disc, wipe them off. (l 27) ≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other than warnings and date indications disappear. ≥ Is the DVD-RAM or the DVD-RW (VR format) write-protected? # Release the protection. (l 82) If the DVD-RAM or DVD-RW (VR format) was protected on another device, release the protection on the same device. ≥ Has the DVD-RW (Video format) or DVD-R been finalized? # After finalizing, the discs become play-only and cannot record. If you un-finalize a DVD-RW (Video format), it can be used for recording. (l 82) ≥ Has the SD card's write protect switch been set to LOCK? # No recording is possible while the write protect switch is set to LOCK. (l 26) ≥ Is the memory of the disc or card full? # If the disc or card has no more available memory, free up some memory by deleting unnecessary scenes (l 71, 78) or use a new disc or card. ≥ Is the unit set to the video recording mode or picture recording mode? # No recording is possible unless the mode dial is at or . ≥ Is the disc cover open? # If the cover is open, this unit may not operate normally. Close the disc cover. ≥ Is the disc scratched or dirty? # Clean the disc. (l 27) If there are scratches on the disc, use a new disc. ≥ The unit is hot. Follow the messages on the display. To use the unit again, turn the unit off and leave it for a while. ≥ Is the AGS function activated? # Record in the normal horizontal position or set [AGS] to [OFF]. (l 45) 128 LSQT1145

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
Others
128
LSQT1145
The remote control does
not function.
≥
Has the button-type battery of the remote control run out?
#
Replace it with a new button-type battery. (
l
20)
The DISC EJECT lever
does not work.
≥
The disc cover will not open unless the unit is powered.
#
Connect a charged battery or AC adaptor.
≥
The DISC EJECT lever does not work when the unit is
connected to the computer. (
l
131, 132)
The disc cannot be read.
≥
Are there fingerprints or dirt on the surface of the disc?
#
If there are fingerprints or dirt on the disc, wipe them off. (
l
27)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥
If you set [SETUP]
>
[DISPLAY]
>
[OFF], indications other than
warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥
Is the DVD-RAM or the DVD-RW (VR format) write-protected?
#
Release the protection. (
l
82) If the DVD-RAM or DVD-RW (VR
format) was protected on another device, release the protection
on the same device.
≥
Has the DVD-RW (Video format) or DVD-R been finalized?
#
After finalizing, the discs become play-only and cannot record. If
you un-finalize a DVD-RW (Video format), it can be used for
recording. (
l
82)
≥
Has the SD card’s write protect switch been set to LOCK?
#
No recording is possible while the write protect switch is set to
LOCK. (
l
26)
≥
Is the memory of the disc or card full?
#
If the disc or card has no more available memory, free up some
memory by deleting unnecessary scenes (
l
71, 78) or use a
new disc or card.
≥
Is the unit set to the video recording mode or picture recording
mode?
#
No recording is possible unless the mode dial is at
or
.
≥
Is the disc cover open?
#
If the cover is open, this unit may not operate normally. Close the
disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥
Is the disc scratched or dirty?
#
Clean the disc. (
l
27) If there are scratches on the disc, use a
new disc.
≥
The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a while.
The unit arbitrarily stops
recording.
≥
Is the AGS function activated?
#
Record in the normal horizontal position or set [AGS] to [OFF].
(
l
45)
Problem
Check points