Panasonic WV-CF294T Color Cctv Camera-english/french - Page 11

Installations and Connections Caution: ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY. The following installation should be made by qualified service personnel or system installers. I Preparations Important: • Procure 4 mounting screws according to the material of the installation area. In this case, wood screws and nails should not be used. Recommended tightening torque is as follows. M4: 1.6 N·m {16 kgf·cm} • Required pull-out capacity of a single screw/bolt is 196 N {20 kgf} or more. • If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced. • The protection sheet attached to the dome cover shall be peeled off after installation. 46 mm {1-13/16"} 4.5 mm Side cable access hole {3/16"} Camera fixing hole ø4 - 4.5 mm {3/16"} Cable access hole for wall/ceiling ø30 - 50 mm {1-3/16" - 2"} UTP cable access hole ø12 mm {1/2"} ø129.5 mm {5-1/8"} 83.5 mm {3-5/16"} G Direct mounting If the camera is directly mounted on a wall/ceiling, align the camera mounting position with the position of the hole through which the cables run and make the hole. If no hole is made through a wall/ceiling and open wiring along a wall/ceiling is used, process the cover so that the cables can be run through the side of the cover. G Using a two-gang junction box When using a two-gang junction box (4" x 4"), procure one locally that meets the dimensions in the figure. And then, locally procure four cameramounting screws suitable for the installation surface and structure of the wall/ceiling or two-gang junction box. Processed section of the side surface of the cover 11