Panasonic WV-CP500 Installation Guide - Page 12

Precautions for installation This camera is designed to be used indoors. This camera is not operable outdoors. Do not operate this product beyond the specified temperature, humidity or power source ratings. Use this product at temperatures within -10 °C to +50 °C {14 °F to 122 °F}, and humidity below 90 %.The input power source is 12 V DC/24 V AC (WV-CP504) or 120 V AC (WV-CP500). Installing place Contact your dealer for assistance if you are unsure of an appropriate place in your particular environment. • Make sure that the installation area is strong enough to hold the camera, such as a concrete ceiling. • If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced. • Do not install this product in a humid or dust-laden environment. Otherwise, lifetime of the internal parts may be shortened. Avoid installing in the following locations. • Locations where it may get wet from rain or water splash • Locations where a chemical agent is used such as a swimming pool • Locations subject to steam and oil smoke such as a kitchen, Locations near flammable gas or vapor • Locations where radiation or x-ray emissions are produced • Locations subject to strong magnetic field or radio waves • Locations where corrosive gas is produced • Locations where it may be damaged by briny air such as seashores • Locations where the temperature is not within -10 °C to +50 °C {14 °F - 122 °F}. 12 • Locations subject to vibrations (This product is not designed for on-vehicle use.) • Locations subject to condensation as the result of severe changes in temperature Avoid installing the camera in a place with a high level of noise. Installation near an air conditioner, an air cleaner, a vending machine, or the like causes noise. Avoid connections during a lightning storm. Otherwise, an electric shock may be caused. Be sure to remove this product if it is not in use. Keep the camera cable away from the lighting cable. Failure to observe this may cause noise. Radio interference When the camera is used near TV/radio antenna, strong electric field or magnetic field (near a motor or a transformer), images may be distorted and noise sound may be produced. Mounting screws • Screws are not supplied with this product. • Prepare them according to the material and strength of the area where the product is to be installed. • Do not use an impact driver. Use of an impact driver may damage the screws. • The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area.