Panasonic WV-CP500 Installation Guide - Page 8

Precautions This product has no power switch. Power is supplied from an external 12 V DC/ 24 V AC (WV-CP504) or 120 V AC (WVCP500) power-supply device. Refer to service personnel for how to turn on/off the power. Use this product for indoor use only. Do not expose this product to direct sunlight for hours and do not install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration and malfunction. Keep this product away from water. To keep on using with stable performance • Parts of this product may deteriorate and it may shorten lifetime of this product when using in locations subject to high temperatures and high humidity. Do not expose this product to direct heat sources such as a heater. • Use this product at temperatures within -10 °C to +50 °C {14 °F to 122 °F}, and humidity below 90 % (when using this product without turning the power off). Do not rub the edges of metal parts with your hand. Failure to observe this may cause injury. Do not attempt to disassemble this product. To prevent electric shock, do not remove screws or covers. There are no user-serviceable parts inside. Ask qualified service personnel for servicing. Handle this product with care. Do not abuse this product. Avoid striking, shaking, etc. The product could be damaged by improper handling or storage. Cleaning this product body Turn the power off when cleaning the product. Use a dry cloth to clean this product. Do 8 not use strong abrasive detergent when cleaning this product. When the dirt is hard to remove, use a mild detergent and wipe gently. Then, wipe off the remaining detergent with a dry cloth. Otherwise, it may cause discoloration. When using a chemical cloth for cleaning, read the caution provided with the chemical cloth product. Noise on monitor This product is equipped with a super sensitive CCD. Therefore, white dot noise may appear on the monitor. This phenomenon is not trouble. Discoloration on the CCD color filter When continuously shooting a bright light source such as a spotlight, the color filter of the CCD may have deteriorated and it may cause discoloration. Even when changing the fixed shooting direction after continuously shooting a spotlight for a certain period, the discoloration may remain. Do not aim this product at strong light sources. A light source such as a spot light causes a blooming (light bleeding) or a smear (vertical lines). Smear Bright subject Blooming Turn the circuit breaker off which supplies this product with the power when abnormal conditions are encountered.