Panasonic WVNP244 WVNP244 User Guide - Page 30
Con the settings relating to the alarm out connector [Alarm output setup], Alarm output setup]
View all Panasonic WVNP244 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Configure the settings relating to the alarm out connector [Alarm output setup] Click the [Alarm] tab on the "Alarm setup" page. (☞ page 16) The settings relating to the alarm out connector can be configured on this page. Refer to pages 28 and 29 for further information about the settings relating to the alarm action and the alarm image. Note: When "Open" is selected, the alarm signal will be output for around 20 seconds when the power of the camera is turned on. [Pulse width] When "Pulse" is selected for "Alarm output", select an pulse width. Available pulse width: 1 - 120 sec Default: 1 sec [Alarm output setup] Select "ON" or "OFF" to determine whether or not to output the alarm signals to the alarm out connector when an alarm is detected. Default: OFF [External terminal output setup] Select "Latch" or "Pulse" for the alarm out connector at an alarm occurrence. Latch: When an alarm is detected, alarm output con- nector will be in the state selected for "Alarm output" until the [Alarm reset] button is clicked. Pulse: When an alarm is detected, alarm output connector will be in the opposite state to the "Alarm output" setting for the period set for "Pulse width". Default: Latch [Alarm Output] Select "Open" or "Close" to determine whether to open or close the alarm output connector when output the alarm signals. Open: The alarm out connector will open when output the alarm signals. (Normally close) Close: The alarm out connector will close when output the alarm signals. (Normally open) Default: Open 30