Pfaff Tiptronic 2030 Owner's Manual - Page 103

Pintuck foot with guide With this foot you can accurately sew pintucks with a spacing of 5 or 11 mm. The same foot allows you to precisely space decorative stitches up to 6 mm wide between the pintucks. Attach the pintuck foot with guide. The foot can be attached with the guide pointing to the left or the right Insert a twin needle (1 .6 or 2 mm space between needles). Thread the two needles (see page 31). Set the needle thread tension tight (4 - 5) and sew one pintuck (see also page 1 03) with or without gimp thread. - Place the first pintuck under the groove in the extended guide. Sew a second pintuck The second pintuck will automatically be spaced to allow a decorative stitch to be sewn in the area between pintucks. - Sew all remaining pintucks. - Replace the twin needles with a normal sewing needle. - Set the needle thread tension to 3. - Place stabilizer under work area. - Place two pintucks in the guides on either side of the center of the foot Embroider your desired decorative stitches in this space. Non-stick fancy stitch foot (for leather) The synthetic coating on the underside of this foot makes it particularly suitable for sewing decorative and utility stitches of up to 6 mm wide on leather, synthetic leather and vinyl. It may be helpful to back these fabrics with a fusible woven or knit interfacing. Due to the stretch of these fabrics, it is important to use a stabilizer under the fabric when embroidering. A needle with a longer eye (system 1 30 N) is recommended for thicker leather. On softer leathers an embroidery needle works well. - Attach non-stick fancy stitch foot - Embroider leather as desired. - Remove stabilizer. WARNING! Very closely set stitch, i.e. short stitch length/tight stitch density, may cause leathers. synthetic leathers and vinyl's to perfo rate. It is important to remember that needle piercing points will remain visible in leather. Program: optional Program: 1 Stitch length: 15 Tension: 3 - 5 108