Pfaff Tiptronic 2030 Owner's Manual - Page 69
position - repairs
View all Pfaff Tiptronic 2030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
A 41 -A - -, -: Darning with the straight stitch Prog. 1 Attach darning foot No. 6 . Turn the handwheel towards you until the needle is set at its highest position. With thumb and index finger press the darning foot together. Insert the pin of the darning foot as far as it will go into the hole of the presser foot holder. The "C-shaped" guide should place itself around the presser bar. The long, plastic arm must be behind the needle clamp/needle set screw. Darning position: Lower the presser bar lifter slowly and push it lightly to the rear until it engages in the darning position. Warning! Only in this position is the thread tension engaged for darning. - Place the work to be repaired in a darning! embroidery hoop. - Lower the feed dog. - Draw up the bobbin thread and hold the threads when you start sewing. - Repair the damaged area/hole by guiding the fabric evenly forwards and backwards. The length of the seam is determined by the size of the hole. When you have covered the width of the damaged area, turn the fabric 90 degrees and stitch over the area again. Darning in both directions over a tear will produce a stronger repair than a single pass. TIP: Remember, when sewing with the feed dogs lowered, the stitch length is determined by you. An even, medium-to-fast sewing speed will allow you to sew a more consistent length of straight stitch. Sewing too slowly may cause small knots to appear on the reverse side of your work 72