Pfaff creative 2.0 Owner's Manual - Page 59
Troubleshooting - problems
View all Pfaff creative 2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Troubleshooting In this troubleshooting guide you will Ànd solutions to the problems you may have with your machine. For further information please contact your local authorized PFAFF® dealer who will be happy to help you. Problem/cause General problems Bobbin alarm does not work? Thread snips do not cut the thread? Fabric does not move? Wrong stitch , irregular or narrow stitch? The needle breaks? The machine will not sew? The sewing and embroidery machine function buttons do not respond to touch? Remedy Clean lint from bobbin area and use only the original PFAFF® bobbins approved for this model. Remove stitch plate and clean lint from bobbin area. Enable automatic thread snips in the settings menu. Make sure that machine is not set in free-motion mode in the settings menu. Make sure that the feed dogs are not lowered. Deactivate twin needle or stitch width safety in the settings menu. Insert needle correctly as described in chapter 2. Attach correct needle for the fabric. Check that all plugs are securely plugged into the machine and into the wall socket. Check that the foot control cord is securely plugged into the foot control. Push bobbin winder lever to sewing position. The sockets and function buttons on the machine can be sensitive to static electricity. If the buttons do not respond to touch, turn the machine OFF and then ON again. If the problem persists, contact your local authorized PFAFF® dealer. The machine skips stitches Did you insert the needle properly? Insert needle correctly as described in chapter 2. Did you insert a wrong needle? Use needle system 130/750 H. Is the needle bent or blunt? Insert a new needle. Did you thread the machine properly? Check how the machine is threaded. Is the correct presser foot used? Attach correct presser foot. Is the needle too small for the thread? Make sure the needle is correct for the thread and fabric. Is the fabric moving up and down with the needle Reduce the presser foot pivot height in the settings when free-motion sewing or embroidering? menu. Maintenance Needle thread breaks Did you insert the needle properly? Insert needle correctly as described in chapter 2. Did you insert a wrong needle? Use needle system 130/750 H. Is the needle bent or blunt? Insert a new needle. Did you thread the machine properly? Check how the machine is threaded. Is the needle too small for the thread? Change the needle to the proper size for the thread. Are you using poor thread with slubs or thread Change to a new higher quality thread purchased which has become dry? from an authorized PFAFF® dealer. Is a correct spool cap used? Attach a spool cap of the right size for the actual thread spool. 7:3