Philips MX5600D User manual - Page 22
Getting Started - power supply
UPC - 037849932025
View all Philips MX5600D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
English Getting Started Step 1: Inserting batteries into the remote control 3 1 2 1 Open the battery compartment. 2 Insert two batteries type R06 or AA, following the indications (+-) inside the compartment. 3 Close the cover. Using the remote control to operate the system 1 Aim the remote control directly at the remote sensor (iR) on the front panel. 2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TV/AV, TUNER.) 3 Then select the desired function (for example ÉÅ, S, T.) OPEN•CLOSE DISC 1 DISC 2 DISC 3 DISC 4 DISC 5 DISC 1 DISC 2 DISC 3 STANDBY- ON iR SENSOR DISC/ TV/AV MEDIA TUNER AUX/DI 1 2 3 4 5 6 7 8 9 SURR. 0 VOL SOUND SYSTEM MENU DISC MENU SEATING ZOOM PREV STOP NEXT OK PLAY/PAUSE DISC SKIP REPEAT REPEAT PROGRAM CAUTION! - Remove batteries if they are exhausted or if the remote is not to be used for a long time. - Do not use old and new or different types of batteries in combination. - Batteries contain chemical substances, so they should be disposed of properly. Step 2: Setting the clock The clock can be set in either 12-hour or 24-hour mode ("12:00 AM" or "00:00" for example.) buttons on front panel CLOCK•TIMER 2 DVD system's display panel SELECT CLOCK OR TIMER CLOCK•TIMER 3 SEARCH 4 CLOCK 01:38 PM PROG 5 13:38 CLOCK•TIMER 6 13:38 1 Press STANDBY ON to switch on the DVD system. 2 Press and hold CLOCK•TIMER until "SELECT CLOCK OR TIMER" appears. 3 Press T (if necessary) to change the display to "CLOCK," then press CLOCK•TIMER again to confirm. 4 Press S / T to set the minutes and hours. To increase the speed, hold down S or T. ➜ The changes in minutes will roll over to the hours. 5 Press PROG to change between 12-hour and 24-hour clock mode. 6 Press CLOCK•TIMER again to store the setting. ➜ The clock will start working. To view the clock time in any active mode G Press CLOCK•TIMER. ➜ The clock will display for a few seconds. Notes: - If the DVD system is disconnected from the power supply, it will erase the clock setting. - If you do not press any buttons within 90 seconds, the system will exit clock setting mode. 20