Pioneer 310-S Owner's Manual - Page 74

12 The Initial Setup menu Video Out settings Audio In settings Component Video Out • Default setting: Interlace You only need to make this setting if you connected this recorder to your TV using the component video jacks. Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback Component Video Out Interlace Progressive If your TV is compatible with progressive-scan component video, set this Progressive for the highest quality picture. If your TV is not compatible with progressive-scan video, leave it set to Interlace. See also Progressive scan video in the glossary on page 94. Important • If you switch to Progressive when using a TV that is not compatible with progressive-scan video, you will not be able to see anything displayed on your TV. If this happens, press and hold PAUSE on the front panel, then press DISC NAVIGATOR. This will set the recorder's video output back to Interlace. Compatibility of this unit with progressive-scan TVs Consumers should note that not all high-definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch the connection to the 'standard definition' output (Interlace). If there are questions regarding our TV set compatibility with this model, please contact our customer service center. This recorder is compatible with the following Pioneer displays and monitors Plasma display • PDP-502MX, PDP-505HD, PDP-5030HD, PDP-4330HD, Pro-1000HD, Pro-800HD, PDP-5031, PDP-4300 Projection monitor receiver • SD-532HD5, SD-533HD5, Pro-700HD, Pro-710HD, Pro-610HD, Pro-510HD, Pro-720HD, Pro-620HD, Pro-520HD, Pro-730HD, Pro-630HD, Pro-530HD, SD-582HDS, SD-641HDS, SD-643HDS External Audio • Default setting: Stereo Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback External Audio Dual Mono Recording DV Input Input Level (L1) Input Level (L2) Input Level (L3) Stereo Dual Mono If the external source is standard stereo, leave set to Stereo. If each channel carries a separate soundtrack, change to Dual Mono. When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or dual mono. This has priority over the setting you make here. Dual Mono Recording • Default setting: L Initial Setup Basic Tuner Video Out Audio In Audio Out Language Recording Playback External Audio L Dual Mono Recording R DV Input Input Level (L1) Input Level (L2) Input Level (L3) When recording a dual mono source from an external input in Video mode or VR mode set to FINE / MN 32, you can choose to record either the L (left), or the R (right) audio channel. Note • If you're recording in VR mode (except when set to FINE / MN 32), both channels will be recorded and you can switch them as you like on playback. 74 En