Pioneer 310-S Owner's Manual - Page 91

Additional information 13 On-screen displays and recorder displays The table below shows a list of error messages that you may encounter when using the recorder and an explanation of their meaning. Message • Initializing disc. Please wait a moment. • Incompatible region number. • Cannot record any more titles. • No more space for file management data. • Cannot add any more chapter marks. • This disc cannot be recorded. Undo the finalization. • Cannot play this disc. • This disc cannot be recorded. • Cannot read the CPRM information. • Could not record the information to the disc. • Cannot edit. • Could not initialize disc. • Could not complete finalization successfully. • Could not undo finalization successfully. • Could not successfully unlock the disc. • Cannot record to a disc that is not CPRM compatible. • Cannot record this content using Video mode recording. • This content is copy protected. • Incorrect CPRM information. • No DV input. • Cannot preview because there is no DV input. • The audio will conform to the [Dual Mono Recording] setting. • Repairing disc. • Could not repair the disc. • Overheating has stopped operation. Press DISPLAY to clear this message. Explanation/Action When you load a blank DVD-RW disc, the recorder automatically initializes it. The disc loaded has an incompatible region number for the recorder and so will not play. The disc control data limit has been reached, or the maximum number of chapters and/or titles has been reached. Erase titles/ chapters or combine chapters. The disc was finalized on a non-Pioneer DVD recorder. Undo the finalization in order to recording/editing. The disc may be dirty or damaged. Take out the disc, clean it and retry. If the error persists, use a new disc. If the error appears even with a new disc, please consult a Pioneer Service Center. The video source is copy-once protected. Use a VR mode DVD-RW disc with CPRM for recording. The video source is copy-protected and cannot be recorded. The recorder could not read the CPRM information. The recorder may be damaged-please consult a Pioneer Service Center. No signal was detected at the DV input/output jack. This may appear if a blank section of DV tape is playing in the connected camcorder. When recording from an external input in Video mode, or in VR mode set to MN 32, audio is recorded in Linear PCM format. You can only record the left or right channel; not both. During recording, the power was cut. This display appears when the power is restored. The recorder was unable to repair the disc after a power cut. The contents of the recording will be lost. The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please contact a Pioneer authorized service center. 91 En