Pioneer 607CMX Technical Manual - Page 11

Connection Panel When installing PDA-5003 S-VIDEO INPUT3 VIDEO INPUT4 INPUT 3/4 AUDIO ANALOG RGB INPUT5 AUDIO IN OUT R L G(ON SYNC) B R HD (H/V SYNC) VD R L ~ !@ # When installing PDA-5004 S-VIDEO INPUT3 AUDIO VIDEO INPUT4 $ COMPONENT AUDIO VIDEO INPUT5 R L IN OUT R L Y Pb/Cb Pr/Cr % AUDIO R L ^ & *( ) _ + Controls and Connectors - = IN OUT COMBINATION RS-232C OUTPUT INPUT1 INPUT2 AUDIO AUDIO AUDIO ANALOG RGB OUT (D-Sub) INPUT1 ANALOG RGB IN (D-Sub) INPUT2 DIGITAL RGB (DVI-D) 1 23 4 Plasma Display Section 1 COMBINATION IN/OUT Never connect any component to these connectors without first consulting your Pioneer installation technician. These connectors are used for Plasma Display setup adjustments. 2 SPEAKER (R) terminal For connection of an external right speaker. Connect a speaker that has an impedance of 6 Ω to 16 Ω. 3 SPEAKER (L) terminal For connection of an external left speaker. Connect a speaker that has an impedance of 6 Ω to 16 Ω. 4 RS-232C Never connect any component to this connector without first consulting your Pioneer installation technician. This connector is used for Plasma Display setup adjustments. 5 AUDIO (OUTPUT) (Stereo mini jack) Use to output the audio of the selected source component connected to this unit to an AV amplifier or similar component. Note: No sound is produced from the AUDIO (OUTPUT) jack when the MAIN POWER switch is set to OFF or when set to Standby. 567 8 9 0 6 AUDIO (INPUT1) (Stereo mini jack) Use to obtain sound when INPUT1 is selected. Connect the audio output jack of components connected to INPUT1 to this unit. 7 AUDIO (INPUT2) (Stereo mini jack) Use to obtain sound when INPUT2 is selected. Connect the audio output jack of components connected to INPUT2 to this unit. 8 ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin) Use the ANALOG RGB OUT (INPUT1) terminal to output the video signal to an external monitor or other component. Note: The video signal is not output from the ANALOG RGB OUT (INPUT1) terminal when the panel's main power is OFF or the panel is in Standby. 9 ANALOG RGB IN (INPUT1) (mini D-sub 15 pin) For connection of a personal computer (PC) or similar component. Confirm that the connection made corresponds to the signal output from the connected component. 0 DIGITAL RGB (INPUT2) (DVI-D jack) Use this input to connect to a computer. Connect to an AV component (HDCP supported) equipped with DVI output connector. - AC IN Use to connect the supplied power cord to an AC outlet. = MAIN POWER switch Use to switch the main power of the unit on and off. 11