Pioneer 607CMX Technical Manual - Page 50

Video Card: PDA-5003/PDA-5004 4.3.3 Installing procedures Installation instructions are listed below. When installing the unit, if a screw or other object should drop inside the Plasma Display, immediately consult your nearest Pioneer Service Center. Continuing operation may damage the panel. This device has been designed for installation on the Pioneer Plasma Display PDP-607CMX. Installation procedures are as follows: Check the following before installing this video card: • Plasma Display is disconnected from the computer and any other devices. • The Plasma Display is unplugged from the wall outlet before installing/removing a card from a panel slot. Installation Notes: • Do not install the PDA-5002 on the PDP-607CMX display units. • When opening the protective cover, take care not to drop screws or other objects in the opening. Objects dropped inside the display may cause damage or malfunction. • When installing a video card, if the Plasma Display is laid with its screen side facing down, the work surface should be flat and level. The packing material, a blanket, or other soft material should be spread on the work surface to protect the screen before laying the panel down. Take care to prevent scratches or other damage to the unit from tools or other objects. Never rest the display on a surface in such a way that weight or pressure is placed only on the screen surface. • This video card has been designed for exclusive use with the Pioneer Plasma Display PDP-607CMX. Do not attempt unauthorized modifications or alterations since malfunction or damage may result. • Take care not to modify or damage the card's internal devices in any way. • Before installation, take precautions to eliminate static electricity on your body. Do not touch the card's circuitry or devices. • This device has not been designed to be repeatedly removed and reinstalled. Avoid removing the card once it is installed. • When installing the PDA-5003, it may be necessary to adjust the impedance selector switch setting. Confirm this item before installing. • Prior to insertion, use a cloth containing ethanol to clean the PCI bus. Wipe in the direction of the electrodes to remove dirt and dust. Wiping with a dry cloth may cause damage due to static electricity. Installation Illustration depicts PDA-5003 model 1 Remove the protective cover over the video card slot on the Plasma Display's terminal panel. Protective cover 2 Align the video card with the two rails visible inside of the port then gently and evenly insert the card. rails Note • Be very careful when inserting the card. Aim the card's mounting surface oriented toward the rear of the Plasma Display. The card or display may be damaged if the card is inserted crookedly or with excessive force. • Impedance selector switch is found only on the PDA5003. Device mounting surface Impedance selector switch S-VIDEO INPUT3 VIDEO INPUT4 INPUT 3/4 AUDIO 75 Ω 2.2 kΩ ANALOG RGB HD (H/V SYNC) INPUT5 AUDIO 3 After inserting the video card all the way into the slot, confirm that it is seated securely. The screws removed in step 1 to secure the card in place. S-VIDEO INPUT3 VIDEO INPUT4 INPUT 3/4 AUDIO ANALOG RGB HD (H/V SYNC) INPUT5 AUDIO 50