Pioneer AVH-X2700BS Owner's Manual - Page 9
On first-time startup
View all Pioneer AVH-X2700BS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Basic operation that angle for safety. ● Do not place a glass or can on the open LCD panel. Adjusting the LCD panel angle X5700BHS X4700BS 1 Press the button. 2 Touch or LCD panel. to adjust the angle of the 3 Touch . Returns to the previous screen. Inserting/ejecting/connecting media CAUTION Do not insert anything other than a disc into the disc-loading slot. Inserting and ejecting a disc Inserting a disc X5700BHS X4700BS 1 Press the button. 2 Touch to open the LCD panel. 3 Insert a disc into the disc-loading slot. Ejecting a disc X5700BHS X4700BS 1 Press the button. 2 Touch to open the LCD panel. 3 Remove the disc, and press the button. Inserting a disc X3700BHS X2700BS X1700S Insert a disc into the disc-loading slot. Ejecting a disc X3700BHS X2700BS X1700S Press button to eject a disc. Plugging and unplugging a USB storage device p This product may not achieve optimum performance with some USB storage devices. p Connection via a USB hub is not possible. p A USB cable is required for connection. 1 Pull out the plug from the USB port of the USB cable. 2 Plug a USB storage device into the USB cable. 1 2 4-speaker system with front and rear speakers, or a 6-speaker system with front and rear speakers and subwoofers. ● Network Mode 2-way+SW Multi amp, multi-speaker system with high speaker, mid speaker and subwoofer for reproduction of high, middle and low frequencies (bands). WARNING Do not use the unit in standard mode when a speaker system for 3-way network mode is connected to this unit. This may cause damage to the speakers. 5 Touch [OK]. The "Smartphone Setup" screen appears. 6 Touch the item you want to set. Information on the connections and functions for each device on page 17 7 Touch . The top menu screen appears. p Once the speaker mode is set, the setting cannot be changed unless this product is restored to the default settings. Restore the default settings to change the speaker mode setting. Restoring the default settings on page 52 Switching the speaker mode 1 USB cable 2 USB storage device Check that no data is being accessed before pulling out the USB storage device. Restore the default setting. Restoring the default settings on page 52 On first-time startup 1 Start the engine to boot up the system. After a short pause, the splash screen comes on for a few seconds. The "Select Program Language" screen appears. p From the second time on, the screen shown will differ depending on the previous conditions. 2 Touch the language that you want to use on screen. 3 Touch . The "Speaker Mode Setting" screen appears. 4 Touch the speaker modes that you want to use. ● Standard Mode 9