Pioneer AVIC-88DVD Other Manual - Page 10

Connecting the System Connecting the power cord (1) Speed detection circuit lead Vehicle injection computer Connector Connection method Pass the extension cord and the lead for the speed detection circuit through this hole. Clamp firmly with needle-nosed pliers. Close the cover. Note: The position of the speed detection circuit depends on the vehicle model. For details, consult your authorized Pioneer dealer or an installation professional. If connection to the speed detection circuit is too difficult, connect the separately sold ND-PG1 speed pulse generator to the pink lead. Note: The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle owner's manual or dealer. LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT Pink (CAR SPEED SIGNAL INPUT) The navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle's speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Failure to make this connection will increase in the location display. IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE'S ANTILOCK BRAKING SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. Connection method Clamp the parking brake switch power supply side lead. Power supply side Clamp firmly with needle-nosed pliers. 9 Ground side Parking brake switch