Pioneer AVIC-88DVD Other Manual - Page 7
Before installing the unit, To prevent damage
View all Pioneer AVIC-88DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH ESPAÑOL DEUTSCH Connecting the System Before installing the unit • This unit is for vehicles with a 12-volt battery and negative grounding. Check the battery voltage of your vehicle before installation. • To avoid shorts in the electrical system, be sure to disconnect the (-) battery cable before beginning installation. To prevent damage • When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector. • If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. F ACC O F O OF OF N STAR N STAR T T ACC position No ACC position • To avoid short-circuiting, cover the disconnected lead with insulating tape. • Attach the connectors of the same color to the corresponding colored port, i.e., yellow connector to the yellow port, black to black, etc. • The black lead is ground. Please ground this lead separately from the ground of highcur- rent products such as power amps. Do not ground more than one product together with the ground from another product. For example, you must separately ground any amplifier unit away from the ground of this unit. Connecting grounds together can cause a fire and/or damage the products if their grounds became detached. • When replacing the fuse, be sure to use only a fuse of the rating prescribed on the fuse holder. FRANÇAIS ITALIANO NEDERLANDS 6