Pioneer AVIC-D2 Owner's Manual - Page 120
Messages and how to react to them - wiring
View all Pioneer AVIC-D2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
NAVI/AV Appendix Messages and how to react to them The following messages may be displayed by your navigation system. ❒ There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display. Message Please insert the appropriate disc. This is not the appropriate disc. Please insert the appropriate disc. Irregular speed pulse signal is detected. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Speed pulse wire is not connected. System will start to learn without speed pulse. Please keep in mind that accuracy is not fully ensured without speed pulse. When If you try to use a disc which is incompatible with this system. If you insert a disc upside down. If the disc is dirty. If the disc is cracked or otherwise damaged. If the Navigation unit does not receive the vehicle speed pulse. The speed signal input (pink lead wire) of the power cable is not connected. Vibration is detected. Please power The navigation system is installed in off the system and check the installa- a place where it may be affected by a tion. After you have checked, please large vibration. re-boot the system and press "OK". Direction of G sensor is not correct. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Direction of G sensor is set incorrectly. Gyro Sensor is not working properly. Abnormal output of Gyrosensor is Please consult your dealer or Pioneer detected. service center. This function is not available now. System detected that the vertical angle of the installation has been changed. Learning status for Gyro Sensor has been initialized. System detected that the vertical angle of the installation exceeds the permission level. Please install the navigation unit correctly. The screen cannot be displayed with Vehicle Dynamics Display. Because the sensor has not been taught so the sensor information cannot be acquired. If the mounting angle of the Hideaway unit has been changed. The navigation system is installed with an extreme angle exceeding the limitation of the installation angle. No data available at this time. If no data is available that can be used with the XM tuner. What to do Insert a suitable disc. Insert the disc with the label upward. Clean the disc. Insert a normal, round disc. Consult your Pioneer dealer. To operate with 3D hybrid mode, connect the speed signal input (pink lead wire) of the power cable correctly. Although it can be operated with Simple hybrid mode without connecting the speed signal input, the precision of the positioning will be less accurate. Re-install the navigation unit in a place where the unit will not be affected by vibration. See the "Installation Manual" and set the direction of the navigation unit correctly. Note down the error code shown on the screen; turn off the power, and then contact your nearest Pioneer service facility. If the sensor learning status reaches the Sensor Initializing status or more, the system is ready to be used. The system initializes the sensor in order to operate it with the maximum performance and automatically starts re-learning. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to "Installation Manual" and "Installation Angle Setup" on page 62.) Wait for a while and try the operation again. 118