Pioneer DJM 3000 Owner's Manual - Page 6
Connections - fader replacement
UPC - 012562585734
View all Pioneer DJM 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
CONNECTIONS When connecting or changing the connection of units, make sure to first turn off the power switch and disconnect the power cord from the outlet. 1. Connection of Input Equipment [A] CDJ-1000 / CDJ-100S / CDJ-700S / CDJ-500II [B] CDJ-1000 / CDJ-100S / CDJ-700S / CDJ-500II CMX-3000 / CMX-5000 [A] [B] SEND R L (MONO) RETURN R L (MONO) R L R L 3 COLD 1 GND 2 HOT MASTER OUT 2 RL RL RL RL MASTER BOOTH OUT 1 MONITOR CH - 4 PHONO 4 LINE 7 CH - 3 PHONO 3 / LINE 6 LINE 5 CH - 2 PHONO 2 / LINE 4 LINE 3 CH - 1 PHONO 1 / LINE 2 LINE 1 L L TALK OVER LEVEL PHONO LINE L L L PHONO LINE PHONO LINE 1 2 DIGITAL OUT SEND R L REC OUT RETURN R L MASTER OUT 2 R MASTER R MASTER OUT 1 BOOTH MONITOR LEVEL ATT. PHONO 4 LINE 7 CONTROL CH - 4 R PHONO 3 LINE 5 / LINE 6 CH - 3 SIGNAL GND CONTROL R PHONO 2 LINE 3 / LINE 4 CH - 2 CONTROL R PHONO 1 LINE 1 CONTROL / LINE 2 CH - 1 CH-4 MIC 3 MIC 2 DJM-3000 RL RL RL RL Connect to a wall's electrical outlet (PHONO 4 cannot be used when using MIC 3) Player 3 Cassette deck, etc. Player 2 Player 1 When connecting an analog player to the CH-4 PHONO 4 connectors, first remove the short-circuit pin plugs (2) from the jacks. The short-circuit pin plugs are provided to reduce any residual noise when an analog player is not connected to the PHONO 4 jacks, thus producing the highest possible sound quality. After removing the pin plugs, store them securely, and replace them in their original jacks any time an analog player is not physically connected. *1 Connect the cord for the analog player's ground. This terminal is exclusively for an analog player and is not a safety earth. *2 If you are using the unit with the separately sold CMX3000, CMX-5000, CDJ-1000, CDJ-100S, CDJ-700S, or CDJ-500 II connected to the LINE terminals, the fader start function can be used if the unit and CD player are connected with a control cord. *3 Because the unit's PHONO input terminals are exclusively for MM, use MM-type cartridges for the analog player connected. 6 *4 When connecting a cassette deck, set the PHONO/LINE switch to the LINE position. *5 When connecting an analog record player, set the PHONO/LINE switch to the PHONO position. Connecting audio cords Use the cords with the red and white pin plugs. Connect the white plug to "L" and the red plug to "R". Make sure to insert the plugs completely. White plug L Red plug R