Pioneer DJM 3000 Owner's Manual - Page 7

2. Connection of Outputs, Microphones, etc. Microphone 1 DJM-3000 CONNECTIONS Headphones Power amplifier Power amplifier Power amplifier External effector (Supports XLR input) (Supports RCA input) (For booth monitor) Microphone 2 DJM-3000 SEND R L (MONO) RETURN R L (MONO) R L R L 3 COLD 1 GND 2 HOT MASTER OUT 2 RL LR MASTER BOOTH OUT 1 MONITOR CH - 4 PHONO 4 LINE 7 CH - 3 PHONO 3 / LINE 6 LINE 5 CH - 2 PHONO 2 / LINE 4 LINE 3 CH - 1 PHONO 1 / LINE 2 LINE 1 L L TALK OVER LEVEL PHONO LINE L L L PHONO LINE PHONO LINE 1 2 DIGITAL OUT SEND R REC L OUT RETURN R L MASTER OUT 2 R MASTER R MASTER OUT 1 BOOTH MONITOR LEVEL ATT. PHONO 4 LINE 7 CONTROL CH - 4 R PHONO 3 LINE 5 / LINE 6 CH - 3 SIGNAL GND CONTROL R PHONO 2 LINE 3 / LINE 4 CH - 2 CONTROL R PHONO 1 LINE 1 CONTROL / LINE 2 CH - 1 CH-4 MIC 3 MIC 2 RL XLR terminal polarity is as shown in the diagram below. CD recorder, etc. Cassette deck, etc. 2 HOT (+) 3 COLD (-) 1 GND MIC 3 (CH-4 PHONO 4 cannot be used when microphone is connected to MIC 3.) *6 MASTER LEVEL ATT. (Master output-level attenuator shaft) This shaft is used to decrease the output level to protect connected amplifiers and speakers from excessive input. (Attenuation: -∞ to 0 dB) *7 Connect if you want to use another device for adjusting sound quality. SEND (output): Connect this to the external effector's input terminal. When using a monaural input effector, connect it to the L channel output. The effector will receive LR-mixed sound. RETURN (input): Connect this to the external effector's output terminal. When using a monaural output effector, connect it to the L channel output. The signals from the effector will be input to both the L and R channels. *8 REC OUT Outputs sound to the same output source as the master output, without being influenced by the master volume, master balance and MONO/STEREO switches. *9 TALK OVER LEVEL attenuation control Attenuates sound level from sources other than MIC 1 and 2 when the MIC switch is set to the TALK OVER position (range: -4 to -20 dB). *10 MIC 1 Supports microphones with either XLR or PHONE type jacks. *11 DIGITAL OUT Outputs same source as the master output. The output level is not affected by MASTER LEVEL ATT. (*6). 7