Pioneer PDP-5080HD Owner's Manual - Page 17

Preparation 05 English PDP-5080HD with the speaker installed (with the Pioneer table top stand) Speaker mounting screw (M5 x 10 mm) Speaker mounting screw (M5 x 10 mm) Speaker mounting screw (M5 x 10 mm) Speaker mounting fitting (side) Speaker cable Speaker Speaker mounting fitting Speaker mounting fitting (center) (side) Bead band Note • Before installing the speaker, make sure that the Pioneer table top stand is attached to the plasma display. 1 Attach the speaker mounting fittings to the rear of the plasma display. • Attach the fittings for right and left sides to the bottom right and left on the rear panel of the plasma display using the supplied screws. • Attach the fitting for center to the lower center on the rear panel of the plasma display using the two supplied screws. ➁ Then, tighten the screw in the oval-shaped screw hole. Speaker mounting screw (M5 x 10 mm) ➀ Tighten the screw in the upper screw hole first. ➁ Then, tighten the screw in the screw hole right under the Speaker mounting fitting for side upper hole. (It shows the attachment of the fitting on the left side. It is attached on the right side by the same procedure.) Speaker mounting screw (M5 x 10 mm) ➀ Tighten the screw in the roundshaped hole first. Speaker mounting fitting for center 17 En