Pioneer PDP-5080HD Owner's Manual - Page 23

Preparation 05 English Attaching the stand again • When the plasma display is mounted without the supplied speaker, begin with step 2 (for PDP-5080HD). • Begin with step 2 for PDP-4280HD. • Besides the speaker, steps for attaching the stand are the same for PDP-5080HD and PDP-4280HD (use the screw holes with "T" inscribed). Illustrations shown are for PDP-5080HD. 1 Detach the supplied speaker when the plasma display is being mounted on the wall, with the speaker attached. • To detach the speaker, remove the cable wiring for the speaker at the rear and screws at the bottom of the speaker and pull it out (see illustrations on page 20). 3 Attach the stand at the points indicated by the arrows and tighten the installation bolts (2) and (1) firmly using a screwdriver. Installation bolts (1): M8 x 23 mm (black) for PDP-4280HD M8 x 23 mm (black) for PDP-5080HD Installation bolts (2): M8 x 60 mm (black) for PDP-4280HD M8 x 40 mm (black) for PDP-5080HD Screw hole with "T" inscribed Installation bolts (1) (Step 2) Installation bolts (2) (Step 1) 2 With the plasma display lying flat, fit the stand's support columns to the bottom of the plasma display as indicated by the arrows, then slowly insert them. • Be extremely careful not to insert the support columns of the stand into any part of the plasma display other than the stand insertion slots. Doing so might damage the plasma display panel or its ports or result in warping of the stand. Line up the column supports with the bottom of the plasma display, as indicated in the accompanying diagram. 4 Replace the plasma display to stand upright. For speaker installation, see "Installing the Pioneer speaker" on page 16 (PDP-5080HD only). Note • Be sure to install the plasma display in a flat, stable location. • Insert the screws into the holes vertically and tighten them. • Place a sheet or protective cover to protect the display from scratches or damage. • Work only with the plasma display lying flat on a table or similar surface. • When lying the plasma display down, be careful not to scratch or damage it. Plasma display Insert the stand into the plasma display so that an arrow with Sheet "FRONT/FACE AVANT" mark inscribed at the bottom of the stand indicates downward. 23 En