Pioneer PDP-5080HD Owner's Manual - Page 88

15 Appendix Chapter 15 Appendix Troubleshooting Problem GENERAL Possible Solution • No power. • Is the power cord disconnected? (See page 25.) • Has  been turned on? (See page 27.) • Check if you pressed TV  on the remote control unit. (See page 27.) If the indicator on the system lights up red, press TV  on the remote control unit or STANDBY/ON on the plasma display. • Power is suddenly turned off. • Is the sleep timer set? (See page 59.) • Check the power control setting. (See page 58.) • The system's internal temperature has increased. Clean the vents, or remove any blocking objects. (See page 16.) • The system cannot be operated. • External influences such as voltage malfunction, static electricity, etc., may cause improper operation. In this case, operate the system after first turning off the power of the plasma display, or unplugging the power cord and re-plugging it in after one to two minutes. • Remote control unit does not operate. • Check if TV  is off. Turn the button on when the POWER ON and STANDBY indicators are off. • Is the Mode switch set correctly? Slide it to the TV position. (See page 15.) • Are batteries inserted with connect polarity (+, -)? (See page 26.) • Are batteries worn out? (Replace with new batteries.) (See page 26.) • Operate the remote control unit while pointing it toward the remote control sensor on the plasma display. (See page 26.) • Are you using it under strong or fluorescent lighting? • Is a fluorescent light illuminating the remote control sensor? • Check if any obstacles exist between the remote control unit and the remote control sensor. • POWER ON indicator or STANDBY indicator is quickly flashing. • Internal protective circuits may have been activated. First turn the power off by removing the AC power cord from the power outlet, and then turn the power on again in after one minute or more. If the problem is not solved with this, contact the nearest Pioneer Authorized Independent Service Company, or the Customer Support Division (see back cover). PICTURE/SOUND • No image and audio is presented. • Check if the input source for video or PC has been unintentionally selected although you want to watch a TV channel. (See page 28.) • Check if you have activated the Parental Control function. (See page 38.) Enter a password to temporarily cancel the Parental Control function. (See page 42.) • Check the cable connection with the antenna. (See page 24.) • Check the cable connection with the other equipment. (See pages 64 to 69.) • No picture. • Is connection to other components correct? (See pages 64 to 69.) • Is a non-compatible PC signal being input? (See page 68.) • Is picture adjustment correct? (See page 55.) • Screen appears dark • Check if any obstacles exist in front of the Room Light Sensor. (See pages 13 and 63.) • Audio is output but no image is presented. • Check if you have selected "Picture Off" for Energy Save. With this option selected, the screen is deactivated; only audio is output. To restore the screen display, press any button other than VOL +/- and MUTING. (See page 58.) • Images are presented but no audio is output. • Check if you have selected the minimum volume. (See page 29.) • Check if you have muted sound. (See page 29.) • When using a video or PC input source, check that the audio terminals are also connected. (See pages 64 to 67 and 68.) • Sound is reversed between the right and • Check if the speaker cable connections have been reversed between the right and left or if the speaker cable left. from either speaker has been disconnected (for PDP-5080HD only). (See page 19.) • Sound is output from only a single • Has the balance been correctly adjusted? (See page 57.) speaker. • Picture is cut off. • Is the image position correct? (See page 60.) • Has the correct screen size been selected? (See page 62.) • Strange color, light color, dark or color • Adjust the picture tone. (See page 55.) misalignment. • Is the room too bright? The picture may look dark in a room that is too bright. 88 En