Pioneer PRO110FD Owner's Manual - Page 19
Installing the Pioneer speaker - stand
UPC - 012562864976
View all Pioneer PRO110FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Preparation 05 Attaching the stand • Steps for attaching the stand are the same for PRO-150FD and PRO-110FD (use the screw holes with "T" inscribed). 1 With the plasma display lying flat, fit the stand's support columns to the bottom of the plasma display as indicated by the arrows, then slowly insert them. • Be extremely careful not to insert the support columns of the stand into any part of the plasma display other than the stand insertion slots. Doing so might damage the plasma display panel or its ports or result in warping of the stand. Plasma display 3 Replace the plasma display to stand upright. For speaker installation, see Installing the Pioneer speaker. Note • Be sure to install the plasma display in a flat, stable location. • Insert the screws into the holes vertically and tighten them. • Place a sheet or protective cover to protect the display from scratches or damage. • Work only with the plasma display lying flat on a table or similar surface. • When lying the plasma display down, be careful not to scratch or damage it. • If the speaker has been installed, it is recommended to detach the speaker before attaching the stand. Installing the Pioneer speaker Insert the stand into the plasma display so that an arrow with "FRONT/FACE AVANT" mark inscribed at the bottom of the stand indicates downward. Sheet (PRO-150FD) 2 Attach the stand at the points indicated by the arrows and tighten the installation bolts (2) and (1) firmly using a screwdriver. Installation bolts (1): M8 x 23 mm (black) for PRO-110FD M6 x 20 mm (black) for PRO-150FD Installation bolts (2): M8 x 40 mm (black) for PRO-110FD M6 x 20 mm (black) for PRO-150FD Installation bolts (1) (Step 2) Installation bolts (2) (Step 1) Caution • Do not move the display holding on to the mounting fittings. This can result in injury or damage to the unit. About the speaker • In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: • Do not use the speaker with anything other than the plasma display. Doing so may result in damage or fire. • Be sure to turn the connected devices off and remove the power cord from the power outlet beforehand when changing the connection or installation method. • When using a tone control function to greatly emphasize treble sounds, do not use excessive amplifier volume. • Please handle the speaker with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. • Placing a CRT computer screen or CRT monitor near to the speaker may result in interference or color distortion. If this happens, distance the monitor from the speaker. Installation • When installing the speaker, do not use any screws other than those supplied, otherwise the speaker may come off from the main unit and fall over. • When installing the speaker, tighten the screws firmly. (PRO-150FD) 19 En