Pioneer PRO110FD Owner's Manual - Page 30

05 Preparation Routing cables When the speaker is installed under the plasma display panel (for PRO-110FD) Rear view Speaker cable Bead band Speed clamp Bead band Attaching speed clamps to the main unit Attach the speed clamps using the three holes (60 inches: four holes) marked with below, depending on your routing system. for PRO-150FD for PRO-110FD Speed clamp Speed clamp Attaching and removing speed clamps Insert [1] into an appropriate hole on the rear of the plasma display and snap [2] into the back of [1] to lock the clamp. Speed clamps are designed to be difficult to undo once in place. Please attach them carefully. Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed. 2 1 Note • Use the supplied bead bands and speed clamps as necessary. • When tidying up your speaker cables, make sure to bundle them so that they are not subjected to any pressure. Connecting the power cord Connect the power cord after all component connections have been completed. Plasma display (rear view) AC IN terminal is located on the upper edge of the compartment. Caution • Use only the supplied power cord. • Be sure to use the specified power supply voltage; neglecting this can result in fire or electric shock. • For the plasma display, a three-core power cord with a ground terminal is used for efficient protection. Always connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded. 30 En Power cord Noise filter Partially eliminates noise caused by the power source. Note • Always turn off the power of the plasma display when connecting or disconnecting power cords. • Disconnect the power cord from the power outlet when the plasma display is not going to be used for a long period of time.