Pioneer PRO110FD Owner's Manual - Page 26

8 mm to 15 mm (3/8 inch to 5/8 inch) 4 mm (5/32 inch) 8 mm to 15 mm (3/8 inch to 5/8 inch) 4 mm (5/32 inch) M8 05 Preparation Preventing the plasma display from falling over After installing the stand, be sure to take special care to ensure that the plasma display will not fall over and is stabilized to both the wall and rack. Stabilizing on a table or rack Stabilize the plasma display as shown in the diagram using the supplied plastic bands and screws. Note • To stabilize the plasma display on a table or rack, also use commercially available wood screws that have a nominal diameter of 4 mm (5/32 inch) and that are at least 20 mm (13/16 inch) long. (PRO-150FD) 20 mm min. (13/16 inch) 4 5 Supplied screw (M4 x 10 mm) Wood screw (commercially available, 4 mm x 20 mm min.) (5/32 inch x 13/16 inch) (PRO-110FD) 20 mm min. (13/16 inch) 4 5 Supplied screw Wood screw Supplied screw (M4 x 10 mm) Wood screw (commercially available, 4 mm x 20 mm min.) (5/32 inch x 13/16 inch) Supplied screw Wood screw Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides. Drill a hole in the middle at the rear of the tabletop panel before using a wood screw. Perform this work the same way on the left and right sides. Using a wall for stabilization 1 Attach falling prevention bolts (hooks) to the plasma display. 2 Use strong cords to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element. Perform this work in the same way on the left and right sides. Note • Use hooks, cords and fittings that are available on the market. Recommended hook: Nominal diameter 8 mm, length 12 mm to 18 mm (0.5 inches to 0.7 inches) 1. Hook 2. Cord Fitting 12 mm to 18 mm (0.5 inches to 0.7 inches) 4 5 26 En