Pioneer PRS-D800 Owner's Manual - Page 10

Section 02 Connecting the units 3 4 15 2 1 Front speaker output (Left) 2 Rear speaker output (Left) 3 RCA input jack A 4 RCA cable (sold separately) 5 From car stereo (RCA output) One-channel input (Mono) When connecting a speaker (Bridge) ! Slide INPUT (input) switch to 1CH position. 2 3 14 1 Speaker output 2 RCA input jack A 3 RCA cable (sold separately) 4 From car stereo (RCA output) WARNING If the battery wire is not securely fixed to the terminal using the terminal screws, there is a risk of overheating, malfunction and injury, including minor burns. 1 Route battery wire from engine compartment to the vehicle interior. After completing all other amplifier connections, finally connect the battery wire terminal of the amplifier to the positive (+) battery terminal. 1 Positive (+) terminal 2 Engine compartment 3 Vehicle interior 4 Fuse (30 A) × 2 5 Insert the O-ring rubber grommet into the vehicle body. 6 Drill a 14 mm (1/2 in.) hole into the vehicle body. 2 Connect the wires to the terminal. Fix the wires securely with the terminal screws. Connecting the power terminal The use of a special red battery and ground wire RD-223 (sold separately), is recommended. Connect the battery wire directly to the car battery positive terminal + and the ground wire to the car body. 10 En