Pioneer PRS-D800 Owner's Manual - Page 12
Before installing the amplifier, Example of installation on, the floor mat or chassis, Installation - model
View all Pioneer PRS-D800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Section 03 Installation Before installing the amplifier WARNING ! To ensure proper installation, use the supplied parts in the manner specified. If any parts other than those supplied are used, they may damage internal parts of the amplifier, or become loose causing the amplifier to shut down. ! Do not install in: - Places where it could injure the driver or passengers if the vehicle stops suddenly. - Places where it may interfere with the dri- ver, such as on the floor in front of the driver's seat. ! Install tapping screws in such a way that the screw tip does not touch any wire. This is important to prevent wires from being cut by vibration of the car, which can result in fire. ! Make sure that wires do not get caught in the sliding mechanism of the seats or touch the legs of a person in the vehicle as short-circuit may result. ! When drilling to install the amplifier, always confirm no parts are behind the panel and protect all cables and important equipment (e.g. fuel/brake lines, wiring) from damage. be dissipated, continuous use under high-volume conditions, etc. In such cases, the amplifier shuts down until it has cooled to a certain designated temperature. ! The optimal installation location differs depending on the car model. Secure the amplifier at a sufficiently rigid location. ! Firstly make temporary connections and check to ensure the amplifier and system operate properly. ! After installing the amplifier, confirm that the spare tire, jack and tools can be easily removed. ! Make sure to hold the middle part of the unit when carrying. If the terminal cover is held to lift the unit, the cover may come off and cause the unit to fall, and result in injury. Example of installation on the floor mat or chassis 1 Install the brackets to the bottom of the unit. CAUTION ! To ensure proper heat dissipation of the ampli- fier, ensure the following during installation: - Allow adequate space above the amplifier for proper ventilation. - Do not cover the amplifier with a floor mat or carpet. ! Always install the amplifier on a flat surface. Do not install the amplifier on a surface that is not flat or on a surface with a protrusion. Doing so could result in malfunction. ! When installing the amplifier, do not allow parts such as extra screws to get caught between the amplifier and the automobile. Doing so could cause malfunction. ! Protection function may activate to protect the amplifier against overheating due to installation in locations where sufficient heat cannot 1 Screws (3 mm × 8 mm) 2 Mounting bracket 12 En