Pioneer SC-LX502 Basic Manual English French/Spanish - Page 15
Step2: Connect the Speakers
View all Pioneer SC-LX502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
> Before Start > Part Names > Install > Initial Setup > Playback Step2: Connect the Speakers 3/8˝ (10 mm) Standard Connections (Pages 8 to 12) Connect 12345678 for a 7.1 channel system. Connect 1234569: for a 5.1.2 channel system. Up to two powered subwoofers can be connected. The same signal is output from each of the SUBWOOFER PRE OUT jacks. 0 You can also connect both 78 and 9:. However, you can only output audio from one of these at a time. When both are connected, you can switch which speakers to prioritize. Press on the remote control (P6) and use "Other" - "Speakers" to switch between surround back speakers and height speakers and to switch speakers A and B. Setup 0 Settings for the speaker configuration you have connected need to be made in "1. Full Auto MCACC" in Initial Setup (P26). b a OR Speaker B Make sure the exposed speaker cables do not stick out of the speaker terminals when connecting. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated. a Speaker Cable, b Subwoofer Cable En 15