Pioneer VSX-1015TX Owner's Manual - Page 16

03 Connecting up Connecting digital audio components The easiest way to hook up this receiver for surround sound (Dolby Digital and DTS sources) is to use a digital input. You can do this by either coaxial or optical connections (you do not need to do both). The quality of these two types of connections is the same but since some digital components only have one type of digital terminal, it is a matter of matching like with like (for example, the coaxial output from the component to coaxial input on the receiver). This receiver has four digital inputs (two coaxial inputs and two optical inputs) on the rear panel. Connect your digital components as shown below. There is one digital output jack which is marked DIGITAL OUT. If you connect this to the optical input on a digital recorder (for example an MD, DAT or CD-R) you can make direct digital recordings with this unit. When connecting your equipment, always make sure the power is turned off and the power cord is disconnected from the AC outlet. • The arrows indicate the direction of the signal. Satellite tuner DIGITAL OUT CD recorder DIGITAL OUT DIGITAL IN DVD or LD player DIGITAL OUT COAX CD player DIGITAL OUT COAX OUT CD IN PLAY ASSIGNABLE IN 14 CD-R/ TAPE/MD IN 1 (TV/ OUT SAT ) REC IN 2 VIDEO1 (CD-R/ IN TAPE/ MD) PLAY ASSIGNABLE 14 IN DVR / VCR OUT IN 3 (DVD/ LD) REC TV/ SAT IN IN 4 (CD) DVD/ LD IN R DIGITAL AM LOOP FM UNBAL 75Ω ANTENNA Y PRE OUT SUBW. CONTROL PB IN OUT CENTER FRONT MONITOR OUT R L R R SUBW. R SURROUND L SURROUND BACK L (Single) CENTER FRONT L VIDEO1 IN IN DVR / VCR OUT TV/ SAT IN R L AUDIO MULTI CH IN SURROUND L DVD/ LD IN VIDEO S - VIDEO VIDEO PR Y IN 1 PB PR Y PB PR C Note • If your digital connections are different from the default settings, you should refer to The Input Assign menu on page 62 to assign the jacks to the proper component(s). • If you have a have a DVD-Audio or SACD compatible player, see Connecting multichannel analog components on page 17. 16 En