Pioneer VSX-1015TX Owner's Manual - Page 58

10 Other connections Chapter 10: Other connections Caution • Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. Plugging in components should be the last connection you make with your system. • Be careful not to allow any contact between speaker wires from different terminals. • You can use speakers with a nominal impedance between 6-16Ω (please see Switching the speaker impedance on page 71 if you plan to use speakers with an impedance of less than 8Ω). Switching the speaker system If you selected Second Zone in Surround back speaker setting on page 40, three speaker system settings are possible using the SPEAKERS button. If you selected Normal (SB) or Front Bi-Amp, the button will simply switch your main speaker system on or off. The options below are for the Second Zone setting only. • Use the SPEAKERS button on the front panel to select a speaker system setting. As mentioned above, if you have selected Normal (SB), the button will simply switch your main speaker system (A) on or off. Second Zone speaker B setup After selecting Second Zone in Surround back speaker setting on page 40, you can use the speakers connected to the (surround back) B speaker terminals on the rear panel to listen to stereo playback in another room. See Switching the speaker system below for the listening options with this setup. 1 Connect a pair of speakers to the surround back speaker terminals on the rear panel. Connect them the same way you connected your speakers in Connecting the speakers on page 20. Make sure to review Hints on speaker placement on page 21 when placing the speakers in another room. 2 Select 'Second Zone' from the 'Surr Back System' menu. See Surround back speaker setting on page 40 to do this. TUNER CONTROL TUNER EDIT TUNING/ STATION MULTI JOG SYSTEM SETUP RETURN BAND INPUT ATT MPX MIDNIGHT/ LOUDNESS FL DIMMER TONE ACOUSTIC DIALOG MULTI CH EQ ENHANCEMENT IN MULTI JOG SIGNAL SELECT EXTENDED MODE SPEAKERS MCACC SETUP MIC VIDEO2 INPUT PHONES MULTI JOG DIGITAL IN S-VIDEO VIDEO L AUDIO R Press repeatedly to choose a speaker system option: • SP A - Sound is output from speaker system A and the same signal is output from the pre-out terminals. • SP B - Sound is output from the two speakers connected to speaker system B. Multichannel sources will not be heard. The same signal is output from the surround back channel pre-out terminals. • SP AB - Sound is output from speaker system A (up to 5 channels, depending on the source), the two speakers in speaker system B, and the subwoofer. The sound from speaker system B will be the same as the sound from speaker system A (multichannel sources will be downmixed to 2 channels). • SP (off) - No sound is output from the speakers. The same sound is output from the pre-out terminals (including from your subwoofer, if connected) as when selecting speaker system A (above). Note • The subwoofer output depends on the settings you made in Manual speaker setup on page 45. However, if SP B is selected above, no sound is heard from the subwoofer (the LFE channel is not downmixed). • Depending on the settings in Surround back speaker setting on page 40 output from the surround back pre-out terminals may change. • All speaker systems (except Second Zone connections) are switched off when headphones are connected. 58 En