Pioneer VSX-21TXH Owner's Manual - Page 39
Connecting a USB device, Plugging in the receiver - & i touch
UPC - 012562957067
View all Pioneer VSX-21TXH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Connecting your equipment 03 Connecting a USB device It is possible to playback files using the USB interface on the front of this receiver. • Switch the receiver into standby then connect your USB device to the USB terminal on the front panel of this receiver. • Push down on the PUSH OPEN tab to access the USB terminal. • For instructions on playing the USB device, see Playing a USB device on page 48. VSX-23TXH: CONTROL ON / OFF MASTER VOLUME MCACC SETUP MIC iPod iPhone USB VIDEO CAMERA HDMI 4 USB mass storage device VSX-21TXH: USB iPod iPhone VIDEO 2 INPUT VIDEO L AUDIO R CONTROL ON / OFF MCACC SETUP MIC USB iPod iPhone VIDEO 2 INPUT VIDEO L AUDIO R MCACC SETUP MIC MASTER VOLUME USB mass storage device Plugging in the receiver Only plug in after you have connected all your components to this receiver, including the speakers. 1 Plug the supplied power cord into the AC IN socket on the back of the receiver. 2 Plug the other end into a power outlet.1 CAUTION • Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once in a while. If you find it damaged, ask your nearest Pioneer authorized independent service company for a replacement. • Do not use any power cord other than the one supplied with this unit. • Do not use the supplied power cord for any purpose other than that described below. • The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g., when on vacation. • Make sure the blue STANDBY/ON light has gone out before unplugging. • If you have connected speakers with a 6 Ω impedance, change the impedance setting before turning on the power. Note 1 After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You cannot carry out any operations during this process. The HDMI indicator in the front panel display blinks during this process, and you can turn on this receiver once it has stopped blinking. When you set the KURO LINK mode to OFF, you can skip this process. For details about the KURO LINK feature, see KURO LINK on page 63. 39 En