Pioneer VSX-21TXH Owner's Manual - Page 73
Controlling the rest of your system, Operating multiple receivers, Setting the remote to control - remote codes
UPC - 012562957067
View all Pioneer VSX-21TXH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Controlling the rest of your system 09 Chapter 9: Controlling the rest of your system Operating multiple receivers The remote control included with this receiver can be used to operate up to three other receivers (of the same model as this receiver) in addition to this receiver. The receiver to be operated is switched by inputting the preset code to set the remote control setting. • Set the remote modes on the receivers before using this function (see Remote Control Mode Setup on page 96). INPUT SELECT 12 HDMI OUT 3 SIGNAL SEL MCACC 45 SLEEP 6 SBch A.ATT DIMMER 789 D.ACCESS CH LEVEL 0 CLASS ENTER AUDIO INFO CH DISP TV CTRL RECEIVER REMOTE SETUP ZONE 2 ZONE 3 MAIN 1 Check the operation selector switch to MAIN. 2 Press RECEIVER . 3 Press and hold REMOTE SETUP, then release it after the LED flashes twice. 4 Use the number buttons to enter the 5-digit preset code (see below). • Receiver 1: 6 1 9 3 5 (Default) • Receiver 2: 6 2 6 3 0 • Receiver 3: 6 2 6 3 1 • Receiver 4: 6 2 6 3 2 When the preset code is fully input, the LED flashes once to indicate that the setting is completed. To operate another receiver, start over from step 1 to input its preset code. Setting the remote to control other components Most components can be assigned to one of the input function buttons (such as DVD or CD) using the component's manufacturer preset code stored in the remote. However, there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using. Note • You can cancel or exit any of the steps by pressing RECEIVER . To go back a step, press RETURN. • After one minute of inactivity, the remote automatically exits the operation. Selecting preset codes directly 1 Press the input function button for the component you want to control.1 When assigning preset codes to TV CONTROL, press TV CTRL here. 2 Press and hold REMOTE SETUP, then release it after the LED flashes twice. 3 Use the number buttons to enter the 5-digit preset code. See Preset code list on page 113. When the preset code is fully input, the LED flashes once to indicate that the setting is completed. 4 Repeat steps 1 through 3 for the other components you want to control. To try out the remote control, switch the component on or off (into standby) by pressing SOURCE. If it doesn't seem to work, select the next code from the list (if there is one). Note 1 You can't assign RECEIVER , TUNER, iPod/USB, XM or SIRIUS. 73 En