Pioneer VSX-21TXH Owner's Manual - Page 60
Using the Virtual Surround Back mode, Setting the Up Mix function, VirtualSB AUTO
UPC - 012562957067
View all Pioneer VSX-21TXH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
06 Listening to your system Using the Virtual Surround Back mode • Default setting: OFF When you're not using surround back speakers, selecting this mode allows you to hear a virtual surround back channel through your surround speakers. You can choose to listen to sources with no surround back channel information, or if the material sounds better in the format (for example, 5.1) for which it was originally encoded, you can have the receiver only apply this effect to 6.1 encoded sources like Dolby Digital EX or DTS-ES.1 • Press SBch repeatedly to cycle the virtual surround back channel options. Each press cycles through the options as follows: • VirtualSB ON - Virtual Surround Back is always used (for example, on 5.1 encoded material) • VirtualSB AUTO - Virtual Surround Back is automatically applied to 6.1 encoded sources (for example, Dolby Digital EX or DTS-ES) • VirtualSB OFF - Virtual Surround Back mode is switched off • Depending on the positions of the speakers and the sound source, in some cases it may not be possible to achieve good results. In this case, set the setting to OFF. Up Mix OFF Up Mix ON L SW C R L SW C R SL SR ? SBL SBR SL SR SBL SBR STANDBY/ON INPUT SELECTOR BAND TUNE TUNE PHASE CONTROL ADVANC PQMLCSACC HDMI ENTER PRESET PRESET TUNER EDIT AUTO SURR/ALC/ STREAM DIRECT SPEASKTEERRSEO MULTI-ZONE CONTROL ON / OFF Setting the Up Mix function In a 7.1-channel surround system with surround speakers placed directly at the sides of the listening position, the surround sound of 5.1-channel sources is heard from the side. The Up Mix function mixes the sound of the surround speakers with the surround back speakers so that the surround sound is heard from diagonally to the rear as it should be.2 • Using the Up Mix function is effective when the speakers in the 7.1-channel surround system are set up as recommended in the example on page 18. PHONES PUSH OPEN 1 Switch the receiver into standby. 2 While holding down ENTER on the front panel, press STANDBY/ON. The display shows RESET NO . Use TUNE +/- (or / on the remote control) to select UP MIX ON , and then use PRESET +/- (or / on the remote control) to select ON or OFF. 3 Press ENTER to confirm. • When set to ON, the UP MIX indicator on the front panel lights. Note 1 • You can't use the Virtual Surround Back mode when the headphones are connected to this receiver or when any of the stereo, Front Stage Surround Advance or Stream Direct mode is selected. • You can only use the Virtual Surround Back mode if the surround speakers are on and the SB setting is set to NO or if Front Bi-Amp, Speaker B or ZONE 2 is selected at Surr Back System. • The Virtual Surround Back mode cannot be applied to sources that do not have surround channel information. 2 • Set to ON regardless of this setting when playing DTS-HD signals. • May automatically be set to OFF even when set to ON, depending on the input signal and listening mode. 60 En