Pioneer VSX-30 Owner's Manual - Page 113
No sound - overheat
UPC - 884938109246
View all Pioneer VSX-30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Additional information 12 Symptom Remedy AMP ERR blinks in the display, then the power automatically switches off. The ADVANCED MCACC blinks and the power does not turn on. • The receiver may have a serious problem. Do not try switching the receiver on. Unplug the receiver from the wall and call a Pioneer authorized independent service company. The blue indicator (at the • There is a problem with the receiver's power unit. The receiver may have a center of the receiver) flashes serious problem. Unplug the receiver from the wall and call a Pioneer and power turns off. authorized independent service company. AMP OVERHEAT and the • Allow the unit to cool down in a well-ventilated place before switching back blue indicator (at the center on. of the receiver) flash and the • Wait at least 1 minute, then try turning the power on again. power turns off. The receiver suddenly power • The power unit is damaged. Unplug the receiver from the wall and call a off or PQLS flashes. Pioneer authorized independent service company. Display blinks 12V TRG ERR. • An error has arisen in the 12 V trigger jacks. Reconnect accurately then turn the power back on. No sound Symptom Remedy No sound is output when an input function is selected. No sound is output from the front speakers. • Check the volume, mute setting (press MUTE) and speaker setting (press SPEAKERS). • Make sure the correct input function is selected. • Check that the MCACC setup microphone is disconnected. • Make sure the correct input signal is selected (press SIGNAL SEL). Note that when PCM is selected, you won't be able to hear any other signal format. • Check that the source component is connected properly (see Connecting your equipment on page 15). • Check that the speakers are connected properly (see Connecting the speakers on page 20). No sound from the surround • Check that the Stereo listening mode or the Front Stage Surround Advance or center speakers. mode isn't selected; select one of the surround listening modes (see Listening in surround sound on page 61). • Check that the surround/center speakers are not set to NO (see Speaker Setting on page 106). • Check the channel level settings (see Channel Level on page 107). • Check the speaker connections (see Connecting the speakers on page 20). No sound from surround back speakers. • Check that the surround back speakers are set to LARGE or SMALL, and the surround speakers are not set to NO (see Speaker Setting on page 106). • Check the speaker connections (see Connecting the speakers on page 20). If only one surround back speaker is connected, make sure it's connected to the left channel speaker terminal. • Surround back speakers will not play while the Speaker System is set to Speaker B and audio is being played through speaker B. 113 En