Pioneer VSX-D498 Owner's Manual - Page 11

SET UP Connections Digital Connections Digital components can be connected as shown below. You can select up to three of the following be assigned to the digital inputs on this unit: DVD/LD, TV/SAT, MD/TAPE1, CD, VCR. To assign the digital inputs, refer to "Setting Up for Surround Sound" on page 15, 19) ANTENNA DIGITAL IN PCM/ OPT 1 OPT 2 FM UNBAL 75Ω DVD 5.1 CH INPUT SURROUND L SUBWOOFER AM LOOP ANTENNA TO MONITOR TV CONTROL OUT IN VIDEO OUT IN IN PCM/ COAX R CENTER IN OUT IN IN OUT IN IN L IN OUT VIDEO IN OUT L R R PLAY REC MD/TAPE 1 PLAY REC CD TAPE 2 MONITOR TV/ DVD/ SAT LD DVD 5.1 CH FRONT VCR » DIGITAL OUT » COAX OUT R A L A B R B L FRONT SPEAKERS RL CAUTION: SPEAKER IMPEDANCE 6Ω OR 8Ω ~ 16Ω / SPEAKER ATTENTION: IMPEDANCE DE HAUT-PARLEURS 6Ω OU 8Ω ~ 16Ω / HAUT-PARLEUR CENTER PREOUT SUB WOOFER PREOUT CENTER SPEAKER RL SURROUND SPEAKERS CAUTION: ATTENTION: SEE INSTRUCTION SE REPOTER AU MANUAL MODE D'EMPLON 8~16Ω / SPEAKER 8~16Ω / HAUT- PARLEUR 6 ~ LESS THAN 8Ω /SPEAKER 6 ~ MOINS DE 8Ω /HAUT-PARLEUR IMPEDANCE SELECTOR » DIGITAL OUT CD player DVD player MD recorder memo When playing LD recorded in Dolby Digital When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator (RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the receiver through the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1. The factory setting for each of the digital inputs is described below. COAX : DVD OPT 1 : CD OPT 2 : MD 7 Digital audio cords/Fiber-optic cables Commercially available digital audio coaxial cord (standard video cords can also be used) or fiber-optic cables (not supplied) are used to connect digital components to this receiver. When you use optical digital input or output terminals, pull off the caps and insert the plugs. Be sure to insert completely. Digital audio cord Fiber-optic cables (or standard video cord) OPERA TION 11