Pioneer VSX-D498 Owner's Manual - Page 26

Switching ANALOG/DIGITAL Signal Input

Get Pioneer VSX-D498 PDF manuals and user guides View all Pioneer VSX-D498 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Sound Modes Switching ANALOG/DIGITAL Signal Input The input of the component set in the digital input setting (refer to page 19) can be switched to an analog or digital input signal by pressing the SIGNAL SELECT button. 1 Press SIGNAL SELECT on the front panel to select the input signal corresponding to the source component. Each press switches between ANALOG and DIGITAL signal selection. SIGNAL SELECT ANALOG SIGNAL SELECT ANALOG SP A SIGNAL SELECT DIGITAL SIGNAL SELECT DIGITAL SP A 2 While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby Digital signal is input. SIGNAL SELECT DIGITAL AC-3 SIGNAL SELECT DIGITAL AC-3 SP A When a Dolgy Digital signal is input. SIGNAL SELECT memo • SIGNAL SELECT is fixed in the "ANALOG" position for components not assigned to one of the three digital input jacks. • Because the audio from a karaoke microphone and LD recorded with analog audio only is not output from the digital output, set SIGNAL SELECT to "ANALOG". • This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and 48kHz), digital signal formats. With digital signal formats other than these, set SIGNAL SELECT to "ANALOG". 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
26
<ARB7192>
Switching ANALOG/DIGITAL Signal Input
The input of the component set in the digital input setting (refer to page 19) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
1
Press
SIGNAL SELECT on the front panel to select the
input signal corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
2
memo
SIGNAL SELECT
Sound Modes
SP
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
A
SP
SIGNAL
SELECT
DIGITAL
SIGNAL
SELECT
DIGITAL
A
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input.
When a Dolgy Digital signal is input.
SP
SIGNAL
SELECT
DIGITAL
AC-3
SIGNAL
SELECT
DIGITAL
AC-3
A
•
SIGNAL SELECT is fixed in the “ANALOG” position for components not
assigned to one of the three digital input jacks.
•
Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to “ANALOG”.
•
This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), digital signal formats. With digital signal formats other than these,
set SIGNAL SELECT to “ANALOG”.