Pioneer VSX-D498 Owner's Manual - Page 45

Additional Information Symptom Cause Broadcast stations cannot be selected • Weak radio signals. automatically. No sound from surround or center speakers. • Speaker settings are incorrect. • The rear and/or center levels are turned down. • The surround and/or center speakers are disconnected. Sound is produced from other components, but not from LD or DVD player. • SIGNAL SELECT is set incorrectly. • The digital inputs are assigned incorrectly, or not at all. Cannot be remote controlled. • The remote control batteries have worn out. • Too far away or bad angle of operation. • There is an obstacle between the receiver and the remote control. • Strong light such as fluorescent light is shining onto the unit's remote control signal lightreceiving window. • A cord is connected to the CONTROL IN terminal on this unit. Remedy • Connect an outdoor antenna (refer to page 8). • Refer to "SPEAKER setting mode" on page 16 to check the speaker settings. • Refer to "Adjusting the speaker volume" on page 20 to check the speaker levels. • Connect the speakers (refer to page 13). • Set SIGNAL SELECT to "DIGITAL" or "ANAROG" according to the type of connections made. (refer to page 26) • Set the digital input setting correctly (refer to page 15, 19). • Replace the batteries (refer to page 6). • Operate within 23 feet (7 m), 30° of the remote sensor on the front panel (refer to page 7). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. • Connect cord to the correct jack. The display is dark. • This is not a malfunction. • In standby, pressing STANDBY/ ON while holding down the button (both on the front panel) returns the display to the default brightness. If the unit does not operate normally due to external effects such as static electricity Disconnect the power plug from the outlet and insert again to return to normal operating conditions. 45