Pioneer VSX-D811S Owner's Manual - Page 44

06 Setting up the receiver Setting the relative volume level of each channel • Default setting: 0db For best surround sound playback, you should set the relative channel levels from the main listening position. You can set seperate levels for each surround mode. 1 Press RCV. 2 Press TEST TONE to output the test tone. The test tone is output in the following order (depending on the speaker setting): FL C SW SL *VSX-D811S only FR SR SB* If you don't hear a test tone from one of your speakers, please refer to Speaker setting on page 39 to make sure you have correctly specified your speaker setup. 3 Press MASTER VOLUME +/- to adjust the volume to an appropriate level. 4 Use LEVEL +/- to adjust the speaker levels in turn. You should hear the test tone at the same volume from each speaker when seated in the main listening position. The channel level range is ± 10 dB. 5 When you're done, press TEST TONE to turn off the test tone. SOURCE RECEIVER DVD RCV TV VCR MULTI CONTROL CD TUN CD-R TVC 1 2 3 TEST TONE 4 INPUT ATT 5 FL DIMMER 6 CH SELECT 7 LEVEL 8 9 +10 EFFECT DISPLAY DISC 0 ENTER DTV INFO ¶ BAND 1 MPX/RETURN D.ACCESS T.EDIT/GUIDE 7 38 CLASS ¡ DTV ON/OFF DTV MENU 4¢ TOP MENU AUDIO SUB TITLE ANGLE REMOTE SETUP STANDARD ADV.SURR. STEREO INPUT SEL. SIGNAL SEL MIDNIGHT/ LOUDNESS MUTE RECEIVER CONTROL TUNE ST U SET P ST ENTER TUNE CHANNEL MENU TV VOL TV INPUT MASTER VOLUME TV TV CONTROL AV PRE-PROGRAMMED REMOTE CONTROL UNIT • Test tone is only output in Standard modes. • Since the subwoofer transmits an ultralow frequency its sound may seem quieter than it actually is. The speaker volume can be adjusted without outputting the test tone by pressing CH SELECT and then using LEVEL +/-. 44 En XRB3013A.38.44 44 01.12.12, 4:46 PM