Pioneer XW-NAV1K-K Operating Instructions - Page 41

Pioneer XW-NAV1K-K Manual

Page 41 highlights

Additional information 13 Do not expose to heat. Do not place this unit on top of an amplifier or other component that generates heat. When placing it in a rack, to avoid the heat given off by the amplifier or other audio component, place it on a shelf below the amplifier. • Turn off the unit's power when not using it. • Depending on signal conditions, striped patterns may appear on a TV screen and noise may enter the sound of radio broadcasts when the unit's power is on. If this happens, turn the unit's power off. • When using chemical-impregnated wipes, etc., read the cautions included with the wipes carefully. English Cleaning the lens • This unit's lens should not become dirty in normal use, but if for some reason it should malfunction due to dust or dirt, consult your nearest Pioneer authorized service center. Although lens cleaners for players are commercially available, we advise against using them since some may damage the lens. Français Español About condensation If this unit is moved suddenly from a cold place into a warm room (in winter, for example) or if the temperature in the room in which this unit is installed rises suddenly due to a heater, etc., water droplets (condensation) may form inside (on operating parts and the lens). When condensation is present, this unit will not operate properly and playback is not possible. Let this unit stand at room temperature for 1 or 2 hours with the power turned on (the time depends on the extent of condensation). The water droplets will dissipate and playback will become possible. Condensation can also occur in the summer if this unit is exposed to the direct wind from an air-conditioner. If this happens, move this unit to a different place. About copyrights This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Rovi Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Rovi Corporation. Reverse engineering or disassembly is prohibited. Cleaning the product • Unplug the power cord from the power outlet when cleaning this unit. • Clean this unit using a soft cloth. For tough dirt, apply some neutral detergent diluted in 5 to 6 parts water to a soft cloth, wring out thoroughly, wipe off the dirt, then wipe again with a soft, dry cloth. • Alcohol, thinner, benzene, insecticides, etc., could cause the print or paint to peel off. Also, leaving rubber or vinyl products in contact with this unit for long periods of time could mar the cabinet. 41 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

Additional information
13
41
En
English
Français
Español
Do not expose to heat.
Do not place this unit on top of an amplifier or
other component that generates heat. When
placing it in a rack, to avoid the heat given off
by the amplifier or other audio component,
place it on a shelf below the amplifier.
Turn off the unit’s power when not using it.
Depending on signal conditions, striped
patterns may appear on a TV screen and
noise may enter the sound of radio
broadcasts when the unit’s power is on. If
this happens, turn the unit’s power off.
About condensation
If this unit is moved suddenly from a cold place
into a warm room (in winter, for example) or if
the temperature in the room in which this unit
is installed rises suddenly due to a heater, etc.,
water droplets (condensation) may form inside
(on operating parts and the lens). When
condensation is present, this unit will not
operate properly and playback is not possible.
Let this unit stand at room temperature for 1 or
2 hours with the power turned on (the time
depends on the extent of condensation). The
water droplets will dissipate and playback will
become possible. Condensation can also
occur in the summer if this unit is exposed to
the direct wind from an air-conditioner. If this
happens, move this unit to a different place.
Cleaning the product
Unplug the power cord from the power
outlet when cleaning this unit.
Clean this unit using a soft cloth. For tough
dirt, apply some neutral detergent diluted
in 5 to 6 parts water to a soft cloth, wring
out thoroughly, wipe off the dirt, then wipe
again with a soft, dry cloth.
Alcohol, thinner, benzene, insecticides,
etc., could cause the print or paint to peel
off. Also, leaving rubber or vinyl products in
contact with this unit for long periods of
time could mar the cabinet.
When using chemical-impregnated wipes,
etc., read the cautions included with the
wipes carefully.
Cleaning the lens
This unit’s lens should not become dirty in
normal use, but if for some reason it
should malfunction due to dust or dirt,
consult your nearest Pioneer authorized
service center. Although lens cleaners for
players are commercially available, we
advise against using them since some may
damage the lens.
About copyrights
This product incorporates copyright protection
technology that is protected by U.S. patents
and other intellectual property rights. Use of
this copyright protection technology must be
authorized by Rovi Corporation, and is
intended for home and other limited viewing
uses only unless otherwise authorized by Rovi
Corporation. Reverse engineering or
disassembly is prohibited.