ProForm 1200 E Elliptical English Manual - Page 7

3. Attach the Track Frame (4) to the Frame (1) with two M10 x 25mm Patch Screws (48) and two 3 M10 Split Washers (85). Tip: Finger tighten a Patch Screw into the lower hole first, and then finger tighten a Patch Screw into the upper hole. Then, tighten both Patch Screws. Tip: This step may be easier if you raise the Frame (1) a few inches in the location shown by the arrow at the right while you attach the Track Frame (4). See the inset drawing. Tighten two Leveling Feet (36) into the underside of the Track Frame (4). 1 4 85 48 85 48 4 36 4. Apply a small amount of the included grease to two Wave Washers (88). 4 Orient a Weld Spacer (89) as shown, and slide it onto the left Crank Arm (83). Identify the Left Track Arm (12), which is marked with a "Left" sticker, and orient it as shown. Slide the Left Track Arm (12) onto the left Crank Arm (83). Then, slide a Wave Washer (88) onto the end of the left Crank Arm. 83 89 11 Repeat this step with the Right Track Arm 88 (11). 12 Grease 7