ProForm 210 Csx Instruction Manual - Page 22
Maintenance And Troubleshooting
View all ProForm 210 Csx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the exercise bike is used. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING Most console problems are the result of low batteries. To replace the batteries, see assembly step 7 on page 9. If the console does not display your heart rate when you use the handgrip heart rate monitor, see step 5 on page 15. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the parts described below. See assembly step 5 on page 8. Using a standard screwdriver, release the tabs along the bottom edges of the Rear and Front Upright Covers (19, 20), remove the two M4 x 12mm Screws (57), and then remove the Rear and Front Upright Covers. Locate the Reed Switch (35). Turn a Crank Arm (60) until a Magnet (39) is aligned with the Reed Switch. Slightly loosen the two indicated M4.5 x 12mm Flange Screws (36). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Flange Screws. 39 36 35 60 Turn the Crank Arm (60) so that the Magnet (39) passes the Reed Switch (35) repeatedly. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the parts that you removed. 22