ProForm 210 Csx Instruction Manual - Page 7
Tip: Avoid pinching the Main Wire 41.
View all ProForm 210 Csx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. If there are shipping brackets (not shown) on the front of the Frame (1), remove the screws from 3 the shipping brackets and discard the screws and the shipping brackets. Set a sturdy piece of packing material (not shown) under the front of the Frame (1). Orient the Front Stabilizer (2) as indicated by the sticker. Attach the Front Stabilizer to the Frame (1) with two M10 x 68mm Screws (44). Then, remove the packing material. 44 2 1 4. Orient the Upright (4) as shown. Tip: Avoid pinching the Main Wire (41). Attach the Upright (4) to the Frame (1) with four M8 x 18mm Screws (42); start all the Screws, and then tighten them. Next, locate the wire tie (A) in the Upright (4). Tie the lower end of the wire tie to the Main Wire (41). Then, pull the upper end of the wire tie until the Main Wire is routed through the Upright. Tip: To prevent the Main Wire (41) from falling into the Upright (4), secure the Main Wire with the wire tie (A). Insert the excess Main Wire (41) into the Upright (4). 4 A Avoid pinching the Main Wire (41) 42 A 41 4 42 1 7