ProForm 920ci English Manual - Page 20

56. Press a 1" x 2" Inner Cap (83) into each end of a Backrest Adjustment Frame (70). Press a 1 1/4" Square Inner Cap (35) into the tube on the Backrest Adjustment Frame. Insert a 1/4" x 1 1/2" Carriage Bolt (101) into the center hole in a Seat Plate (65). Attach the Seat Plate to the Press Backrest (99) with two 1/4" x 3/4" Bolts (49). Insert the 1/4" x 1 1/2" Carriage Bolt (101) into the indicated hole in the Backrest Adjustment Frame (70) and secure it with a 1/4" Flat Washer (71) and a 1/4" Nylon Locknut (68). Secure the other end of the Backrest (99) with a 1/4" x 1 1/2" Bolt (82) and a 1/4" Flat Washer (71). Pull the indicated Adjustment Knob (78) and slide the tube on the Backrest Adjustment Frame (70) into the Press Upright (2). Snap the Knob into a hole in the Frame and turn it clockwise until it is tight. 57. Insert a 1/4" x 2 1/2" Carriage Bolt (45) into the center hole in a Seat Plate (65). Attach the Seat Plate to a Seat (13) with two 1/4" x 3/4" Bolts (49). Insert the 1/4" x 2 1/2" Carriage Bolt (45) into the indicated hole in the Press Seat Frame (7) and tighten a 1/4" Flat Washer (71) and a 1/4" Nylon Locknut (68) onto it. Attach the other end of the Seat (13) with a 1/4" x 2 1/2" Bolt (79) and a 1/4" Flat Washer. 58. Press 3/4" Round Inner Caps (43) into the ends of both Pad Tubes (42). Insert one Pad Tube (42) into the Leg Lever (41). Slide a Foam Pad (30) onto each end of the Pad Tube. Insert the other Pad Tube (42) into the Butterfly Front Leg (3). Slide a Foam Pad (30) onto each end of the Pad Tube. 56 99 83 71 82 2 35 70 78 68 49 65 101 57 71 83 13 65 49 7 71 45 79 68 58 43 30 43 3 30 42 43 42 41 43 59. Remove the pre-assembled 1/4" x 5/8" Screws (95) from the Weight Top Frame (66). Orient one Right Shroud (34) and one Left Shroud (109) as shown. Attach the Shrouds to the brackets on the Weight Top Frame (66) with the 1/4" x 5/8" Screws (95). 59 66 95 109 34 20