ProForm 920ci English Manual - Page 25
ProForm 920ci Manual
View all ProForm 920ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Adjusting the Press Plate 22 Remove the Lock Pin (22) from the Press Plate (55) and the Press Front Leg (20). Align the holes in the Press Plate (55) with the desired set of holes in the Press Front Leg (20). Re-insert the Lock Pin (22) through the Press Front Leg and the Press Plate. 55 20 Trouble-shooting and Maintenance Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. Tightening the Cables Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the cables in several different ways: A. Move the indicated 3 1/2" Pulley (24) to another set of holes in the bracket on the Press Upright (2). Moving the Pulley closer to the Press Upright will tighten the cables. Moving it further away from the Upright will loosen the cable. B. Remove the 3 1/2" Pulley (24) and the Cable Trap (25) from a set of Pulley Plates (23). Re-attach the Pulley and the Cable Trap to the inner hole in the Pulley Plates with the 3/8" x 2" Bolt (54) and the 3/8" Nylon Locknut (50). Note: If the Cable is still too loose after moving a Pulley, repeat the process with another Pulley. B A 7 24 2 23 Adjustment holes 50 54 25 24 25