ProForm 920ci English Manual - Page 4

Assembly Make sure you have the following tools: Make Assembly Easier for Yourself! Everything in this manual is designed to ensure that the weight system can be assembled successfully by anyone. Before beginning assembly, make sure to read the information on this page; this brief introduction will save you much more time than it takes to read it! • Two adjustable wrenches • One standard screwdriver • One phillips screwdriver • One rubber mallet • You will also need grease or petroleum jelly, a small amount of soapy water, and clear tape or masking tape. Note: Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. Assembly Requires Two Persons For your convenience and safety, assemble the weight system with the help of another person. Set Aside Enough Time Due to the many features of the weight system, the assembly process will require a few hours. By setting aside plenty of time and by deciding to make the task enjoyable, assembly will go smoothly. You may want to assemble the weight system over a couple of evenings. How to Identify Parts To help you identify the small parts used in assembly, we have included a PART IDENTIFICATION CHART in the center of this manual. Place the chart on the floor and use it to easily identify parts during each assembly step. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached. Select a Location for the Weight System Because of its weight and size, the weight system should be assembled in the location where it will be used. Make sure that there is enough room to walk around the weight system as you assemble it. How to Orient Parts As you assemble the weight system, make sure that all parts are oriented exactly as shown in the drawings. How to Unpack the Box To make assembly as easy as possible, we have divided the assembly process into four stages. The parts needed for each stage are found in individual bags. Important: Wait until you begin each stage to open the parts bag for that stage. Place all parts of the weight system in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Tightening Parts Tighten all parts as you assemble them, unless instructed to do otherwise. Questions? If you have questions after reading the assembly instructions, please call our Customer Service Department toll-free at 1-800-999-3756 Monday through Friday, 6 a.m. until 6 p.m. Mountain Time. Frame Assembly You will begin by assembling the base and the upright frames that serve as the skeleton of the equipment. Arm Assembly Next you will assemble the press and butterfly arms that you operate while you are exercising. Cable Assembly During this stage you will attach the cables and pulleys that connect the moving arms with each other and with the weights. Seat Assembly During this stage you will assemble the seats and backrests. 4