Pyle PDMT08 PDMT08 Manual 1 - Page 11

Dc Voltage Measurements

Get Pyle PDMT08 PDF manuals and user guides View all Pyle PDMT08 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

1.ALWAYS turn the function switch to the OFF position when the meter is not in use. 2.If "OL" appears in the display during a measurement, the value exceeds the range you have selected. Change to a higher range. NOTE: On some low AC and DC voltage ranges, with the test leads not connected to a device, the display may show a random, changing reading. This is normal and is caused by the high-input sensitivity. The reading will stabilize and give a proper measurement when connected to a circuit. DC VOLTAGE MEASUREMENTS CAUTION: Do not measure DC voltages if a motor on the circuit is being switched ON or OFF. Large voltage surges may occur that can damage the meter. 1. Set the function switch to the highest V DC position. 2. Insert the black test lead banana plug into the negative (COM) jack. Insert the red test lead banana plug into the positive (V) jack. 3. Touch the black test probe tip to the 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
11
1.ALWAYS turn the function switch to the OFF position when the
meter is not in use.
2.If “OL” appears in the display during a measurement, the value
exceeds the range you have selected. Change to a higher range.
NOTE
: On some low AC and DC voltage ranges, with the test leads
not connected to a device, the display may show a random,
changing reading. This is normal and is caused by the high-input
sensitivity. The reading will stabilize and give a proper measurement
when connected to a circuit.
DC VOLTAGE MEASUREMENTS
CAUTION:
Do not measure DC voltages if a motor on the
circuit is being switched ON or OFF. Large voltage surges may
occur that can damage the meter.
1.
Set the function switch to the highest V
DC position.
2.
Insert the black test lead banana plug
into the negative (COM) jack.
Insert the red test lead banana plug
into the positive (V) jack.
3.
Touch the black test probe tip to the