Pyle PDMT08 PDMT08 Manual 1 - Page 15

Resistance Measurements

Get Pyle PDMT08 PDF manuals and user guides View all Pyle PDMT08 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

RESISTANCE MEASUREMENTS WARNING: To avoid electric shock, disconnect power to the unit under test and discharge all capacitors before taking any resistance measurements. Remove the batteries and unplug the line cords. 1. Set the function switch to the highest  position. 2. Insert the black test lead banana plug into the negative (COM) jack Insert the red test lead banana plug into the positive  jack. 3. Touch the test probe tips across the circuit or part under test. It is best to disconnect one side of the part under test so the rest of the circuit will not interfere with the resistance reading. 4. Read the resistance in the display and then set the function switch to the lowest  position that is greater than the actual or any anticipated resistance. The display will indicate the proper decimal point and value. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
15
RESISTANCE MEASUREMENTS
WARNING:
To avoid electric shock, disconnect power to the unit
under test and discharge all capacitors before taking any
resistance measurements. Remove the batteries and unplug the
line cords.
1.
Set the function switch to the highest
position.
2.
Insert the black test lead banana
plug into the negative (COM) jack
Insert the red test lead banana
plug into the positive
jack.
3.
Touch the test probe tips across
the circuit or part under test. It is
best to disconnect one side of the
part under test so the rest of the
circuit will not interfere with the
resistance reading.
4.
Read the resistance in the display and then set the function
switch to the lowest
position that is greater than the actual
or any anticipated resistance. The display will indicate the
proper decimal point and value.