Pyle PDMT08 PDMT08 Manual 1 - Page 14

For current measurements up to 200mA

Get Pyle PDMT08 PDF manuals and user guides View all Pyle PDMT08 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

2. For current measurements up to 200mA DC, set the function switch to the highest DC mA position and insert the red test lead banana plug into the (mA) jack. 3. For current measurements up to 10A DC, set the function switch to the 10A range and insert the red test lead banana plug into the (10A) jack. 4. Remove power from the circuit under test, then open up the circuit at the point where you wish to measure current. 5. Touch the black test probe tip to the negative side of the circuit. Touch the red test probe tip to the positive side of the circuit. 6. Apply power to the circuit. 7. Read the current in the display. For mA DC measurements, reset the function switch to successively lower mA DC positions to obtain a higher resolution reading. The display will indicate the proper decimal point and value. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
14
2. For current measurements up to 200mA
DC, set the function switch to the
highest DC mA position and insert
the red test lead banana plug into the
(mA) jack.
3. For current measurements up to 10A
DC, set the function switch to the
10A range and insert the red test
lead banana plug into the (10A) jack.
4. Remove power from the circuit under test, then open up the
circuit at the point where you wish to measure current.
5. Touch the black test probe tip to the negative side of the circuit.
Touch the red test probe tip to the positive side of the circuit.
6. Apply power to the circuit.
7.
Read the current in the display. For mA DC measurements, reset
the function switch to successively lower mA DC positions to
obtain a higher resolution reading. The display will indicate the
proper decimal point and value.