RCA DRC620N User Guide - Page 5

Installing the Battery Battery lock OPEN Connections and Setup 1. Slide the battery lock on the left side of the unit to the OPEN position to open the battery compartment. 2. Slide the battery into the compartment with the battery labeling facing up and the arrow pointing toward the unit. Push it all the way in until it snaps into place. Note: Contact the applicable local governmental office and your current waste removal provider for assistance in determining the appropriate disposal method in your area for old batteries. Removing the Battery If you need to remove the battery in the future, use the following steps: 1. Slide the battery lock on the left side of the unit to the OPEN position to open the battery compartment. 2. Use your thumb to press the battery release tab (on the right side of the battery compartment) to the right.The battery releases and you can pull it out. Installing the Battery in the Remote Control Remove the battery holder from the remote control, insert a CR2025 battery, and reinsert the battery holder into the remote control. Battery holder Release CR2025 tab In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. Replace only with the type of batteries specified above. Do not throw them into fire, do not recharge them. If you are not using the remote control unit for an extended period (several weeks), take the battery out. To remove the battery holder from the remote, use your thumb to push the release tab of the battery holder on the bottom of the remote to the right.Then, while holding the tab to the right, pull out the battery holder with your index finger. 3 Graphics are for representation only.Your unit may differ slightly.